Instructions / Assembly

ManualsBrandsMOEN ManualsBathKleo Single Hole Single-Handle Mid-Arc Bathroom Faucet in Chrome

ONEHANDLE LAVATORY FAUCET

MEZCLADORA MONOMANDO

PARA LAVABO

ROBINET DE LAVABO À UNE

POIGNÉE

Please Contact Moen First

For Installation Help, Missing or

Replacement Parts

(USA)

1-800-BUY-MOEN (1-800-289-6636)

Mon - Fri 8:00 AM to 8:00 PM, Eastern

Sat. 9:00 AM to 5:30 PM Eastern

WWW.MOEN.COM

(Canada)

1-800-465-6130

Mon - Fri 7:30 AM to 7:00 PM, Eastern

WWW.MOEN.CA

Por favor, contacte primero con Moen

Para la ayuda de Instalación, los

Desaparecidos o las Piezas de Recambio

01-800-718-4345

Lunes a viernes de 8:00 a 20:00 hs.

(Costa Este)

Sáb. 8:00 a 18:30 hs. (Costa Este)

WWW.MOEN.MX

Veuillez d’abord contacter Moen

en cas de problèmes avec l’installation, ou pour

obtenir toute pièce manquante ou de rechange

1-800-465-6130

Du lundi au vendredi :

de 7 h 30 à19 h, HE

WWW.MOEN.CA

INS10083A -8/13

Installation Guide

Guía de Instalación

Guide d’installation

HELPFUL TOOLS

For safety and ease of faucet replacement, Moen

recommends the use of these helpful tools.

HERRAMIENTAS ÚTILES

Para que el cambio de la llave sea fácil y seguro, Moen le

recomienda usar estas útiles herramientas.

OUTILS UTILES

Par mesure de sécurité et pour faciliter l’installation,

Moen suggère l’utilisation des outils suivants.

*Images may not match your purchased faucet, but step-by-step

directions are the same.

*Las imágenes pueden no corresponder a la mezcladora que

adquirió pero las instrucciones paso a paso son las mismas.

*Les images du robinet illustré peuvent ne pas correspondre au

robinet que vous avez acheté, mais les directives d’installation

détaillées sont les mêmes.

Summary of content (8 pages)

PAGE 1
INS10083A -8/13 Please Contact Moen First For Installation Help, Missing or Replacement Parts (USA) 1-800-BUY-MOEN (1-800-289-6636) Mon - Fri 8:00 AM to 8:00 PM, Eastern Sat. 9:00 AM to 5:30 PM Eastern WWW.MOEN.COM Installation Guide Guía de Instalación Guide d’installation (Canada) 1-800-465-6130 Mon - Fri 7:30 AM to 7:00 PM, Eastern www.moen.
PAGE 2
D H U I F J G K L V M N O P Q R E S T Parts List A. Faucet Body B. Mounting Bracket C. Mounting Nut D. 3 Hole Deck Plate E. Mounting Tool F. Aerator Removal Tool G. Deck Gasket H. Drain Plug I. Lift Rod J. Pivot Rod Clip K. Waste Seat L. M. N. O. P. Q. R. S. T. U. V. Liste des pièces Drain Gasket Drain Washer Drain Nut Drain O-Ring Tail Piece Pivot Rod Seal Pivot Rod Pivot Rod Nut Pivot Rod Strap Foam Gasket Product Identification Label A. B. C. D. E. F. G.
PAGE 3
INS10083A -8/13 CAUTION — TIPS FOR REMOVAL OF OLD FAUCET: Always turn water supply OFF before removing existing faucet or disassembling the valve. Open faucet handle to relieve water pressure and ensure that complete water shut-off has been accomplished. Icon Legend/Leyenda de Iconos/ Légende des icônes PRECAUCIÓN — CONSEJOS PARA CAMBIAR LA LLAVE MEZCLADORA Siempre CIERRE la toma de agua antes de quitar la llave existente o demontar la válvula.
PAGE 4
2 3 <1" (25mm) For Deck Thickness less than 1" Para el grueso de la cubierta menos que 1" Pour l'épaisseur de plate-forme moins que 1" Option/Opción/Option >1" (25mm) B C For Deck Thickness more than 1" Para el grueso de la cubierta más que 1" Pour l'épaisseur de plate-forme plus que 1" From below the sink, slide the mounting bracket (B) onto the threaded shank. Por debajo del fregadero, deslice la ménsula de montaje (B) sobre el tubo roscado.
PAGE 5
INS10083A INS1970 - 12/11 -8/13 7 6 K K K O N L M K P N Apply a generous amount of plumbers putty or other sealant to the underside of the waste seat (K) flange as shown. Insert (K) into the drain opening in the sink. From the underside of the sink, slide the drain gasket (L) follwed by the drain washer (M) onto the waste seat. Thread the drain nut (N) onto the waste seat (K). Position the black rubber o-ring (O) in the groove at the top of the tail piece (P) and thread onto the drain seat (K).
PAGE 6
11 10 Q S R H Verify that the white plastic pivot rod seal (Q) is in place with beveled side facing out. The pivot rod (R) can be installed two ways the illustration shows the pivot rod in the EASY CLEAN position which allows the plug to be pulled out for cleaning. The other option (Illustrated in the inset) shows the pivot rod installed in the VANDAL PROOF position. The end of the pivot rod (R) is inserted into the opening at the bottom of the plug (H).
PAGE 7
INS10083A INS1970 - 12/11 -8/13 14 13 T I Loosen the pivot rod strap (T) bolt enough to allow the lift rod to move. Position the lift rod knob 1/8" above the faucet and the drain plug 1/2" above the drain seat. Tighten the lift rod strap bolt with a wrench. Attach the hot supply on the left side to the hot water shut off valve and tighten with a wrench. Do not use thread seal tape. Repeat these steps for the cold side. If the supply lines are too long, looping is acceptable.
PAGE 8
Moen Limited Lifetime Warranty Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser for as long as the original consumer purchaser owns their home (the “Warranty Period” for homeowners), that this faucet will be leak- and drip-free during normal use and all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship.