Faucet OWNER'S MANUAL 7025, 7030, 7034, 7037 87025, 87030, 87034 Series

HELPLINE: 1-877-DRINK-H2O

1-877-(374-6542)

INSTALLATION INSTRUCTIONS

CAUTION: Always turn water supplies OFF before removing existing

faucet. Turn faucet on to relieve water pressure and to ensure water is

completely off.

OLD FAUCET REMOVAL: Your old faucet may attach in a number of different

ways depending on the brand. To remove, reverse steps in installation

instruction sheet of old faucet, follow instructions in a DIY type of book or

follow instructions listed below.

After years of use, you may need to use a penetrating oil spray on the faucet

mounting hardware to help loosen corrosion and assist in removing the faucet

connections.

Disconnect water supply lines from faucet supply lines. Remove mounting

hardware using a basin wrench or channel lock pliers. Lift out faucet.

Thoroughly clean and dry the mounting surface after removal of old faucet.

INSTALLING THE PURETOUCH

Classic

FILTERING FAUCET SYSTEM

Helpful Tools: Phillips screwdriver, two adjustable wrenches

CAUTION: Do not use with portable washing devices, i.e.

dishwashers, washing machines.

NOTE: Do not bend supply tubes until instructed in step 4.

HINTS:

When using flexible supplies, we recommend threaded fittings be installed

onto supply lines before placing faucet through sink holes (see step 6). For

installations on tile countertops, remove rubber gasket from underneath support

plate (31) or deck ring (20) and apply a bead of putty in its place. Roll the putty into

the diameter of a pencil. When applied in the groove, the putty should protrude a

minimum of 1/16".

Side Spray Installation (side spray models only)

1. Locate foam gasket on hose guide (25) by sliding gasket onto shank and tucking

outer edge of gasket under the hose guide (25). Do not drive the center of the

gasket up into the hose guide. Install hose guide (25) through furthest left or

right hole in sink. From under sink, thread extended locknut (27) (either side

up) on shank of hose guide and tighten by hand. Feed spray hose (26) down

through the hose guide (25) (do not connect spray hose to faucet until step 6 ).

INS215A