Specification

Kyvos™ Technical Specication
Double Robe Hook BP3703
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
BP3703CH – Double Robe Hook
Chrome Finish
BP3703BN – Double Robe Hook
Brushed Nickel
1. Remove the mounting bracket from the body by loosening the set screw.
2. Position the assembled unit on the wall where desired.
3. Lightly mark the outline of each base.
4. Center a mounting bracket within each base outline with “UP” facing you.
5. Mark the 2 large hole locations of each mounting bracket.
6. Attach each mounting bracket to the wall, using the wall anchors provided
7. Mount each base on the corresponding mounting bracket. Check and make
sure that the base set screw hole(s) are facing down. Assemble a set screw
to each base. Use the allen wrench included in hardware kit to tighten each
set screw and secure the assembly to the mounting bracket(s).
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry
well. Do not use commercial or abrasive cleaners.
Double Robe Hook is constructed of zinc.
Stock Number: _______________ Double Robe Hook
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2016 Moen Incorporated. Moen is a registered trademark and Kyvos is a trademark of
Moen Incorporated. All rights reserved.
1-7/16"
(36mm)
2-3/16"
(55mm)
3-7/8"
(98mm)