Installation Guide
Paper Holder posts are die cast from
highest quality zinc alloy (zamac) and
finished in a high quality powder
coating or metallic plated finish.
Roller is plated plastic and spring
loaded.
5308CH (BP5308CH) – Paper Holder
Polished Chrome Finish
Concealed Screw Mounting
Matching Roller
BP5308OWB – Paper Holder
Old World Bronze Finish
Concealed Screw Mounting
Matching Roller
BP5308SN – Paper Holder
Satin Nickel Finish
Concealed Screw Mounting
Matching Chrome Roller
“BP” skus in wholesale packaging
Cleaning Instructions:
25300 AL M OEN DRIVE NORT H OL M ST E D, OH 44070 (80 0 ) 3 2 1 -8809
FAX: (80 0 ) 848 -6636 INT ERNAT IONAL: (4 4 0 ) 962 -2000
FAX: (44 0 ) 962 -2726 CUST OM ER SE RVICE (USA): 800 -882-0116
WWW.M OEN.COM
©Cop yri ght Creati ve Speci a l ti e s Inte rn a ti on a l L i te ra ture #BA1071
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Place each mounting plate on the template with “UP” facing you.
3. One at a time, place each anchor screw through the mounting plate, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
4. Only insert screw ½ to ¾ of the way into wall.
5. After all screws are installed, tear the template away from the wall
6. Tighten all 4 screws. Do not over tighten.
7. Position each end post with the setscrew down and place over mounting
plate. Tighten the setscrew at the bottom of each base.
8. Compress the paper holder bar and place into both post holes.
Stock Number:______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
5308
Yorkshire Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.