Installation Guide

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Paper Holder is die cast from highest
quality zinc alloy (zamac) and finished
in a high quality powder coating or
metallic plated finish. Matching roller
is plastic and spring loaded.
 BP6908CH – Paper Holder
Polished Chrome Finish
Concealed Screw Mounting
 BP6908OWB - Paper Holder
Old World Bronze Finish
Concealed Crew Mounting
 DN6908PW (BP6908PW) – Paper
Holder
Pewter Finish
Concealed Screw Mounting
“BP” skus in wholesale packaging
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Place each mounting plate on the template with “UP” facing you.
3. One at a time, place each anchor screw through the mounting plate, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
4. Only insert screw ½ to ¾ of the way into wall.
5. After all screws are installed, tear the template away from the wall
6. Tighten all 4 screws. Do not over tighten.
7. Position each end post with the setscrew down and place over mounting
plate. Tighten the setscrew at the bottom of each base.
8. Compress the paper holder bar and place into both post holes.
Stock Number:______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN6908
Madison Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1015