Installation Sheet

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006
Paper Holder
is die cast from highest
quality zinc alloy (zamac). Castings
are plated with a polished brass or
polished chrome finish or powder
coated white. Matching roller is
plastic and spring loaded.
q
DN6908CH
(BP6908CH)
–
Paper
Holder
Polished Chrome Finish
Concealed Screw Mounting
q DN6908CB (BP6908CB) – Paper
Holder
Chrome & Brass Finish
Concealed Screw Mounting
q DN6908W – Paper Holder
White Finish
Concealed Screw Mounting
q DN6908PW (BP6908PW) – Paper
Holder
Pewter Finish
Concealed Screw Mounting
“BP” skus in wholesale packaging
Cleaning Instructions:
1.
Position
the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Place each mounting plate on the template with “UP” facing you.
3. One at a time, place each anchor screw through the mounting plate, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
4. Only insert screw ½ to ¾ of the way into wall.
5. After all screws are installed, tear the template away from the wall
6. Tighten all 4 screws. Do not over tighten.
7. Position each end post with the setscrew down and place over mounting
plate. Tighten the setscrew at the bottom of each base.
8.
Compress the paper holder bar and place into both post
holes.
Stock Number:
______________________Paper Holder
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN6908
Madison Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1015