Operating Guide
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: (800) 848- 6636
INTERNATIONAL: (440) 962- 2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
WWW.CSI.MOEN.COM
Copyright Creative Specialties International
Robe Hook
is constructed of zinc.
q DN0703BN – Robe Hook
Brushed Nickel Finish
q DN0703CH – Robe Hook
Chrome Finish
Cleaning Instructions:
Stock Number:
______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN0703
Iso Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1398
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws only.
1. Remove mounting posts from the product assemblies by loosening each
setscrew.
2. Position the mounting plate on the wall at desired location with “UP”
facing
you. Mark hole locations.
3. Drill two holes as marked using a 5/16” drill bit.
4. Fold ends of the plastic toggle together and insert into each hole in the
wall.
5. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor.
6. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with
“UP” facing you.
8. Tighten screws
9. Place decorative product over the mounting plate with the
setscrew facing
down. Tighten setscrew.