Operating Guide

Directions below are for installation into drywall. If installing product into a stud,
use the wood screws only.
1) Remove mounting post from product assembly by loosening the setscrew.
2) Position the mounting post on the wall at desired location with notch facing
downward, and mark both vertical hole locations.
3) Drill 2 holes as marked using 5/16” drill bit.
4) Fold ends of the plastic toggle anchor together (see Figure 1) and insert into
each hole in the wall.
5) Lightly tap anchors until flush with the wall.
6) One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7) Place mounting post over anchors (with “UP” facing you) and insert screws
through post into anchors.
8) Tighten screws.
9) Place assembly over the mounting post with setscrew facing down and
tighten setscrew.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creative Specialties International 200
6
Literature #BA1
2
4
8
Towel Ring
b
ase is constructed of
zinc. Ring is constructed of brass
(BN) or aluminum (CH).
q
DN
26
86
B
N
–
Towel Ring
Brushed Nickel Finish
q DN2686CH – Towel Ring
Chrome Finish
Cleaning Instructions:
Stock Number:
______________________Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Ring
DN2686
Glenshire™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.