Use and Care Guide

Double Towel Bar
post is die cast
from the highest quality zinc alloy
(Zamac). Casting is plated in chrome,
brushed nickel or oil rubbed bronze.
Towel bar is aluminum for brushed
nickel and chrome finishes and brass
for oil rubbed bronze.
§
DN3622BN
–
24” Double Towel Bar
Brushed Nickel
§ DN3622CH – 24” Double Towel Bar
Chrome Finish
§ DN3622ORB – 24” Double Towel
Bar
Oil Rubbed Bronze
Cleaning Instructions:
Stock Number:
_____________________24” Double Towel
Bar By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
24” Double Towel Bar
DN3622
Bradshaw™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creative Specialties International 2006 Literature # BA1511
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew.
9. Place the mounting plate on the wall over the installed wall anchors with “UP”
facing you.
10. Insert screws through the mounting plate into the anchors. Tighten the
screws.
11. Assemble the towel bar and posts.
12. While assembled, position each end post with setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.