Instructions / Assembly

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Paper Holder is constructed of
wrought iron. Black finish is powder
coated. Natural finish is painted and
has an acrylic coating for added
protection.
 DN4908BK – Paper Holder
Black Finish
Cleaning Instructions:
Stock Number:________________Toilet Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN4908
Sienna® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1077
2.30 IN
3.50 IN DEEP
FROM FRONT
OF TP HOLDER
TO WALL
3.80 IN
1. Remove the mounting bracket from the body by loosening the setscrew.
2. Position the assembled unit on the wall where desired.
3. Lightly mark the outline of each base.
4. Center a mounting bracket within each base outline with “UP” facing you.
5. Mark the 2 small hole locations of each mounting bracket.
6. Drill a 5/16” hole at each mounting bracket hole location.
7. Fold ends of the plastic toggle together and insert into each 5/16” hole.
8. Tap anchor flush to the wall.
9. Insert plastic pin into anchor and lightly tap to expand anchor open. (Do not
force or hammer pin)
10. Remove pin from anchor.
11. Place each mounting bracket over the wall anchors, lining up the holes.
12. Insert a screw through the mounting bracket slots into each wall anchor until
tight. Do not over tighten.
13. Place product over the mounting bracket. Check and make sure that the base
set screw hole is facing down.
14. Assemble the set screw to the base. Use the hex wrench included in hardware
kit to tighten the set screw and secure the assembly to the mounting bracket.