Installation Guide

Double Towel Bar
is constructed of
wrought iron. Black finish is powder
coated. Natural finish is painted and
has an acrylic coating for added
protection.
q
DN4922BK
–
24” Double Towel Bar
Black Finish
q DN4922NTL – 24” Double Towel Bar
Natural Finish
Cleaning Instructions:
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 [phone] •
FAX: [phone] • INTERNATIONAL: (440) 962- 2000 •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882
-
0116
1.
Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove the mounting bracket from the body by loosening the setscrew.
3. Place each mounting plate on the template with “UP” facing you.
4. One at a time, place each anchor screw through the mounting plate, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
5. Only insert screw ½ to ¾ of the way into wall.
6. After all screws are installed, tear the template away from the wall
7. Tighten all 4 screws. Do not over tighten.
8. Assemble the towel bar and posts.
9. While assembled, position each end post with the setscrew down and place
over both mounting plates. Tighten the setscrew at the bottom of each base.
Stock Number:
______________________Towel Bar
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Double Towel Bar
DN4922
Sienna Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA1079