Installation Guide

Robe Hook is constructed of zinc.
 DN6703BN – Robe Hook
Brushed Nickel Finish
 DN6703ORB – Robe Hook
Oil Rubbed Bronze Finish
Cleaning Instructions:
25 30 0 AL M OEN DRIVE  NORT H OLM S T E D, OH 4 40 70 (80 0) 32 1 -8809 
FAX: [phone]  INT E RNAT IONAL : (4 4 0 ) 962 -2000 
FAX: [phone] CUST OM E R S ERVICE (US A): 80 0 -882-0116
WWW.MOEN.COM
©Copyright Creative Specialties International Literature #BA1138
1. Remove the mounting post from the body by loosening the setscrew.
2. Position the mounting post on the wall at desired location with notch facing
down.
3. One at a time, place each anchor screw through the 2 large mounting post
holes, centered in the large hole. Using a Phillips screwdriver, turn the
anchor screw while applying pressure. Screw will self drill and tap into
drywall. Do not over tighten.
4. Place skirt over mounting post.
5. Then place post assembly or robe hook over mounting post and skirt with
setscrew facing down.
6. Tighten setscrew.
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN6703
Danbury® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.