Installation Guide

1. Remove existing tank lever.
2. Remove the brass arm mechanism
from the new tank lever by loosening
screw A.
3. Position the new tank lever through
the flush tank hole.
4. The tank lever handle should be
pointing away from the toilet bowl.
5. Install the brass nut inside the tank
and tighten. Depending on the
curvature of the tank, there might be
a slight gap between the outside of
the tank and the base of the lever.
6. Loosen, but do not remove screw B
on the arm mechanism.
7. Replace the entire brass arm
mechanism onto the tank lever.
8. Tighten screw A.
9. Adjust the brass arm mechanism so it
does not come in contact with the
tank wall or any part of the flush
mechanism parts inside the tank.
10. Tighten the adjustment screw (screw
B) on the brass arm mechanism.
11. Attach the flapper valve chain to one
of the three holes provided on the
brass arm.
12. Make sure that the arm does not
activate, and no water is leaking thru
the flapper valve when the handle is
in its normal position, (not flushing).
q
DN
6
8
0
1
CH
–
Tank Lever
Chrome Finish
q DN6801BN – Tank Lever
Brushed Nickel Finish
Cleaning Instructions:
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800- 882-0116 • FAX: [phone]

Copyright Creative Specialties International 2004 Literature #BA1223
Tank Lever
is constructed of zinc.
Stock Number:
______________________
Tank Lever
By Creative Specialties
Installation
Instructions:
Materials
:
Stock Numbers:
Dimensions:
Tank Lever
DN6801
Sage™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.