Installation Sheet

Towel bar
posts are constructed of
zinc. CH bar is aluminum. BN bar is
brass.
q
DN
6818CH
–
18” Towel Bar
Chrome Finish
q DN6824CH – 24” Towel Bar
Chrome Finish
q DN6818BN – 18” Towel Bar
Brushed Nickel Finish
q DN6824BN – 24” Towel Bar
Brushed Nickel Finish
Cleaning Instructions:
1.
Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove each mounting post from the body by loosening the setscrew.
3. Place each mounting post on the template with notch facing down.
4.
One at a time, place each anchor screw through the mounting post, centered
in the large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall.
5. Only insert screw ½ to ¾ of the way.
6. After all screws are installed, tear the template away from the wall.
7. Tighten all 4 the screws. Do not over tighten.
8. Assemble the Towel bar and posts.
9. While assembled, Position each end post with the setscrew down and place
over mounting posts. Tighten the setscrew at the bottom of each base.
Stock Number:
______________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN6818 & DN6824
Sage Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Length 18" 24"
Dim. A 18.00 24.00
Dim. B 20.38 26.38
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800- 882-0116 • FAX: [phone]

Copyright Creative Specialties International 2003 Literature #BA1146