Installation Guide

Oval Tilting Mirror
posts are
constructed of zinc and mirror is
constructed of 5MM thick glass.
q
DN
6892BN
–
Oval Tilting Mirror
Brushed Nickel Finish
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Using a ¼” diameter drill bit, drill 4 holes as indicated on the template.
3. Remove template from the wall.
4. Remove the screws and washers from each of the 4 wall anchors in the
hardware kit. Set the screws and washers aside for later use.
5. Insert the hollow wall anchors into the 4 holes in the wall by lightly tapping with
a hammer until flush.
6. Remove mounting posts from end post assembly by loosening each setscrew.
7. One at a time, place each mounting post over the wall anchors with notch
facing down. Insert the screws and washers through the slots in the mounting
posts and into the wall anchors.
8. To activate the wall anchors, turn screws until you feel increased resistance.
9. Loosen the 2 small screws on each of the end posts.
10. With the back of the mirror facing you, slide the end posts into position on the
mirror (See figure 1). Align the screws with the holes in the back plates.
Tighten all 4 screws.
11. Place mirror assembly over the mounting posts on the wall (setscrews facing
down). Tighten setscre
ws.
Stock Number:
___________________Oval Tilting Mirror
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Oval Tilting Mirror
DN
6892
Sage™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882- 0116 • FAX: [phone]

Copyright Creative Specialties International 2005 Literature #BA1270