Full Product Manual
Towel bar posts are constructed of
zinc. Bar is constructed of brass.
DN7718BN – 18” Towel Bar
Brushed Nickel Finish
DN7724BN – 24” Towel Bar
Brushed Nickel Finish
DN7718CH – 18” Towel Bar
Chrome Finish
DN7724CH – 24” Towel Bar
Chrome Finish
Cleaning Instructions:
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together (see Figure 1) and insert into each hole
in the w all.
6. Lightly tap anchors until flush w ith the w all.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor (see Figure 2). Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew .
9. One at a time, place each mounting post over anchors (notch facing dow nw ard)
and insert screw s through post into anchors.
10. Tighten screw s.
11. Assemble the tow el bar and posts.
12. While assembled, position each end post w ith setscrew s facing dow n and place
over both mounting posts. Tighten the setscrew at the bottom of each post.
Stock Number:_________________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN7718 & DN7724
Lounge™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN D RIVE N ORTH OLMSTED, OH 44070
C OR POR ATE H EADQU AR TER S: (800) 321 -8809 F AX: (800) 848 -6636
I N TERN ATI ON AL: (440) 962 -2000 FAX: (440) 962 -2726
C U STOMER SER VI C E (U SA): 800-882-0116 F AX: (888) 379 -2720
W W W.MOEN. C OM
Copyright Creative Specialties International Literature #BA1314