Installation Sheet

Directions below are for installation into drywall. If installing product into a stud, use the
wood screws only.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each setscrew.
9. One at a time, place each mounting post over anchors (with UP facing you) and
insert screws through post into anchors.
10. Tighten screws.
11. Assemble the towel bar and posts.
12. While assembled, position each end post with setscrews facing down and place
over both mounting posts. Tighten the setscrew at the bottom of each post.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006 Literature #BA1247
Towel bar
posts are constructed of
zinc. Bar is constructed of brass (BN)
or aluminum (CH).
q
DN
26
18
B
N
–
18” Towel Bar
Brushed Nickel Finish
q DN2624BN – 24” Towel Bar
Brushed Nickel Finish
q DN2618CH – 18” Towel Bar
Chrome Finish
q DN2624CH – 24” Towel Bar
Chrome Finish
Cleaning Instructions:
Stock Number:
________________
______Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN
26
18 & DN
26
24
Glenshire™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.