Full Product Manual

Paper Holder is constructed of zinc.
 DN8308BN – Paper Holder
Brushed Nickel Finish
 DN8308CH – Paper Holder
Chrome Finish
Cleaning Instructions:
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for dryw all installation).
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together (see Figure 1) and insert into each hole in
the w all.
6. Lightly tap anchors until flush w ith the w all.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew .
9. One at a time, place each mounting post over anchors (notch facing dow nw ard)
and insert screw s through post into anchors.
10. Tighten screw s.
11. Place each assembly over the mounting posts w ith setscrew s facing dow n.
Pivoting post w ith bar should be on the left side. Tighten both setscrew s.
Stock Number:______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN8308
Retreat® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN D R I VE  N OR TH OLMSTED , O H 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: (800) 848 -6636
I N TER N ATI ON AL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: (888) 379 -2720
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1325