Specification Sheet

Paper Holder
is constructed of zinc.
q
DN
83
08
B
N
–
Paper Holder
Brushed Nickel Finish
q DN8308CH – Paper Holder
Chrome Finish
q DN8308TB – Paper Holder
Tuscan Bronze Finish
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).
4. Remove the template from the wall.
5.
Fold ends of the plastic toggle together (see Figure 1) and insert into each hole in
the wall.
6. Lightly tap anchors until flush with the wall.
7.
One at a time, insert plastic pin into each of the anchors and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew.
9. One at a time, place each mounting post over anchors (notch facing downward)
and insert screws through post into anchors.
10. Tighten screws.
11. Place each assembly over the mounting posts with setscrews facing down.
Pivoting post with bar should be on the left side.
Tighten both setscrews.
Stock Number:
______________________
Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
DN8308
Retreat™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]

Copyright Creative Specialties International 2005 Literature #BA1325