Specification Sheet

Robe Hook
is die cast from highest
quality zinc alloy (zamac). Castings
are triple plated with a polished
brass, polished chrome, or matte
pewter finish.
q
DN8403PB
–
Robe Hook
Polished Brass Finish
Concealed Screw Mounting
q DN8403CH – Robe Hook
Polished Chrome Finish
Concealed Screw Mounting
q DN8403MPW – Robe Hook
Matte Pewter Finish
Concealed Screw Mounting
q DN8403BN – Robe Hook
Brushed Nickel Finish
Concealed Screw Mounting
Cleaning Instructions:
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 [phone] •
FAX: [phone] • INTERNATIONAL: (440) 962- 2000 •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882
-
0116
1.
Position the mounting plate on the wall at desired location
with “UP”
facing you.
2. One at a time, place each anchor screw through the mounting plate,
centered in each large hole. Using a Phillips screwdriver, turn the anchor
screw while applying pressure. Screw will self drill and tap into drywall.
Do not over tighten.
3. Place assembly over the mounting post, setscrew facing down.
4. Tighten setscrew.
Stock Number:
______________________Robe Hook
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN8403
Preston Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Copyright CSI Bath Furnishing Division of Moen 02/22/01
Literature #BA1045