Full Product Manual

Robe Hook is constructed of zinc.
 DN8503BN – Robe Hook
Brushed Nickel Finish
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  FAX: [phone]
I NTER N ATI ON AL: (440) 962 -2000  F AX: [phone]
C USTOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W WW . MOEN . C OM
Copyright Creative Specialties International Literature #BA1308
Cleaning Instructions:
1. Remove mounting post from product assembly by loosening the setscrew .
2. Position the mounting post on the w all at desired location w ith notch facing
dow nw ard, and mark both horizontal hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together (see Figure 1) and insert into
each hole in the w all.
5. Lightly tap anchors until flush w ith the w all.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor (see Figure 2). Remove pin and repeat on other anchor.
7. Place mounting post over anchors w ith notch facing dow nw ard, and insert
screw s through post into anchors.
8. Tighten screw s.
9. Place assembly over the mounting post w ith setscrew facing dow n and tighten
setscrew .
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN8503
Cabrina® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.