Use and Care Guide

Peened grab bar
rods
are formed
from 18–gauge (.049) type 304
stainless steel tubing with a satin
finish.
q
R8712P
–
12” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
q R8718P – 18” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
q R8724P – 24” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
q R8730P – 30” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
q R8736P – 36” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
q R8742P – 42” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
q R8748P – 48” Grab Bar
Stainless Steel Peened Finish
Concealed Screw Mounting
1 ¼” Diameter Bar
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 [phone] •
FAX: [phone] • INTERNATIONAL: (440) 962- 2000 •
FAX: (440) 962
-
2726 CUSTOMER SERVICE (USA): 800
-
882
-
0116
1. All screws must mount firmly into a wood stud.
2. Place the grab bar on the wall in the desired location. Use a level, if
desired, to verify placement.
3. With a pencil, lightly mark the (6) mounting hole locations.
4. Mounting unit on wall using the #10 2” screws (provided).
5. Snap flange covers into place.
Stock Number:
______________________Grab Bar
By CSI Bath Furnishings
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
1 ¼” Peened Grab Bar
–
Concealed Screw
R8700
Home Care Technical Specification

Copyright CSI Bath Furnishing Division of Moen 02/22/01
Compliance:
- ADA Compliant
- Tested to 300 lbs. pull
A B C
R8712P 12.00 8.86 15.14
R8718P 18.00 14.86 21.14
R8724P 24.00 20.86 27.14
R8730P 30.00 26.86 33.14
R8736P 36.00 32.86 39.14
R8742P 42.00 38.86 45.14
R8748P 48.00 44.86 51.14