Installation Guide

MT021A
(78397)
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nut is in place. The cartridge and
retainer nut were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through
the handling of the valve by any number of persons the retainer nut may not be properly installed. This should be carefully checked at
time of rough-in and trim-out. If the retainer nut is not properly installed, water pressure could force the cartridge out of the casting.
Personal injury or water damage to the premises could result.
CAUTION:
Always turn water off before disassembling the valve. Open both faucet handles to
alleviate water pressure to insure that complete water shut-off has been accomplished.
by MOEN
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT AT INSTALLATION SITE
SANI-STREAM
®
FRICTION WASHER
Installation:
1. Thoroughly grease spout o-rings with grease pack provided.
2.
Insert spout into faucet with a twisting motion.
(Not
e: I
f stationar
y sp
out is desir
ed, install friction washer into faucet outlet before inserting spout).
3.
T
igh
t
en spout nut.
4. Flush the spout of any dirt or foreign material by removing the aerator and slowly turning on both hot and and cold supplies.
5.
R
eplace aerator.
NOTE: For double jointed spout part number S0012, grease the o-rings in both the upper and lower joints.