Full Product Manual

 Y1518CH – 18” Towel Bar

Chrome Finish

 Y1518BN – 18” Towel Bar

Brushed Nickel Finish

 Y1524CH – 24” Towel Bar

Chrome Finish

 Y1524BN – 24” Towel Bar

Brushed Nickel Finish

25300 AL MO E N D R I VE  NO RTH O L M S TE D, OH 4 4 0 70

CO R P O RAT E HE A D Q U A RT ER S : ( 8 00 ) 3 2 1 -88 0 9  FA X: (800) 8 4 8 - 6 6 3 6

IN T E R NAT IO N A L : (440 ) 9 6 2 - 2 0 00  F A X: ( 4 4 0 ) 962 -2726

CU S T O M ER S ER V ICE ( US A): 800 -882 - 0 1 1 6  FA X: ( 88 8 ) 3 7 9 - 2720

W WW . MO E N .C O M

Towel Bar is constructed of zinc.

Cleaning Instructions:

Stock Number: ______________ Towel Bar

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

18 in. & 24 in. Towel Bar

Y1518 & Y1524

Darcy

™

Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer, level, tape

Hardware Kit Contents: 2 anchors, 1 hex wrench

Note: Directions below are for installation into drywall. If installing product

into a stud, use the wood screws only.

1) Remove mounting posts from the product assemblies by loosening each

setscrew.

2) Position the mounting plate on the wall in the desired location and mark

holes at the Horizontal screw location on the template if installing into

drywall or vertical screw location if installing into a stud.

3) Drill 1/4” pilot holes in marked locations.

4) Lightly tap anchors until flush with the wall.

5) Place each mounting plate over anchors and insert screws through post

into anchors.

6) Tighten screws.

7) Place posts over the mounting plates with setscrew facing down and

tighten setscrew.