Installation Guide

 Y2686BN – Towel Ring
Brushed Nickel Finish
 Y2686BRB – Towel Ring
Mediterranean Bronze Finish
 Y2686CH – Towel Ring
Chrome Finish
25300 AL MOEN DR I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I NTER NATI ON AL: (440) 962 -2000  FAX: [phone]
C USTOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W WW . MOEN . COM
Copyright Creative Specialties International Literature # BA1443
Towel Ring post is die cast from
highest quality zinc alloy (Zamac).
Casting is plated in Chrome, Brushed
Nickel or Mediterranean Bronze.
Towel ring is aluminum for Brushed
Nickel and Chrome finishes and
stainless steel for Mediterranean
Bronze.
Cleaning Instructions:
1. Remove mounting plate from hardware pack.
2. Position the mounting plate on the wall at desired location with
“UP” facing you. Mark hole locations.
3. Drill two holes as marked using a 5/16” drill bit.
4. Fold ends of the plastic toggle together and insert into each hole
in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor.
7. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with setscrew
facing down and tighten setscrew.
Stock Number:______________________ Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Ring
Y2686
Banbury® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.