Installation Guide

Dartmoor
™
Technical Specication
YB2118
18" Towel Bar
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Installation Instructions:
☐ YB2118CH – 18" Towel Bar
Chrome Finish
☐ YB2118BN – 18" Towel Bar
Brushed Nickel Finish
☐ YB2118ORB – 18" Towel Bar
Oil Rubbed Bronze Finish
18" Towel Bar is constructed of zinc.
Stock Number: 18" Towel Bar
By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
1. Remove the mounting bracket from the body by loosening the setscrew.
2. Position the assembled unit on the wall where desired.
3. Lightly mark the outline of each base.
4. Center a mounting bracket within each base outline with “UP” facing you.
5. Mark the 2 large hole locations of each mounting bracket.
6. Attach each mounting bracket to the wall, using the wall anchors provided
7. Mount each base on the corresponding mounting bracket. Check and make
sure that the base set screw hole(s) are facing down. Assemble a set screw
to each base. Use the allen wrench included in hardware kit to tighten each
set screw and secure the assembly to the mounting bracket(s).
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
18"
457mm
5/8"
16mm
3-1/2"
89mm
3-1/8"
79mm