Full Product Manual

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800- 882- 0116 • FAX: [phone]
WWW.CSI.MOEN.COM

Copyright Creative Specialties International 2006
Towel Bar
posts are constructed of
zinc. Bar is aluminum.
q
YB2218BN
–
18”
Towel Bar
Brushed Nickel Finish
q YB2224BN – 24” Towel Bar
Brushed Nickel Finish
q YB2218CH – 18” Towel Bar
Chrome Finish
q YB2224CH – 24” Towel Bar
Chrome Finish
q YB2218ORB – 18” Towel Bar
Oil Rubbed Bronze Finish
q YB2224ORB – 24” Towel Bar
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:
______________________Towel Bar
By Creative Specialties
Materials:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
YB2218 & YB22
24
Brantford™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1396
Directions below are for installation into drywall. If installing product into
a stud, use the wood screws only.
1.Mark the appropriate distance for your towel bar on the wall where
you want to install the product.
2.Use a level to ensure that the pilot holes will be perfectly level.
3.Using ¼” drill bit, drill one pilot hole for each post.
4.Position mounting posts to wall by inserting wall anchors into pilot
holes and pressing firmly. (Make sure that locking tab on mounting
post is facing down.)
5.Tighten wall anchor screw while holding mounting post firmly in place.
Tighten anchor until resistance increases. DO NOT over tighten.
6.Using tip of screw bit press wall spikes (metal pieces on outer edge of
mounting post) into drywall.
7.Towel bar must be attached to mounting posts as a unit – insert towel
bar into each post.
8.Attach posts by pressing firmly to mounting posts until it clicks. (The
square opening at the base of the post must be facing down to match-
up with locking tab).
Installation Instructions: