Full Product Manual

Paper Holder
is constructed of
zinc
.
q
YB2
8
08BN
–
Pivoting Paper
Holder
Brushed Nickel Finish
q YB2808CH – Pivoting Paper
Holder
Chrome Finish
q YB2808ORB – Pivoting Paper
Holder
Oil Rubbed Bronze Finish
Cleaning Instructions:
This product features the Pro+Fit Installation Mounting System. If you do not
have the Pro+Fit Installation Template please use the following instructions.
(Note: only one hole is required per mounting post.)
1. Mark on the wall where you want to install the product.
2. Using ¼” drill bit, drill one pilot hole for the post.
3. Position mounting post to wall by inserting wall anchor into pilot hole and
pressing firmly.
4. Make sure that locking tab on mounting post is facing down (6 o’clock).
5. Tighten wall anchor screw while holding mounting post firmly in place. DO
NOT over tighten (6 – 8 full turns will secure the anchor).
6. Attach post by pressing firmly to mounting post until it clicks. (The square
opening at the base of the post must be facing down to match-up with
locking tab.)
If you are mounting any parts into a hard surface snap off the anti-rotation fins
on the back of the mounting post.
Stock Number:
______________________Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Paper Holder
YB2808
Eva™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882- 0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006 Literature #BA1345