Manualshelf

Installation Guide

ManualsBrandsMOEN ManualsBathAlign 36 in. Grab Bar in Brushed Nickel
1
Align Technical Specication
Grab Bar
YG0412/YG0418/YG0424/YG0436/YG0442
Stock Numbers:
Materials:
Compliance:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YG0412CH – 12" Grab Bar
Chrome Finish
YG0418CH – 18" Grab Bar
Chrome Finish
YG0424CH – 24" Grab Bar
Chrome Finish
YG0436CH – 36" Grab Bar
Chrome Finish
YG0442CH – 42" Grab Bar
Chrome Finish
YG0412BN – 12" Grab Bar
Brushed Nickel Finish
YG0418BN – 18" Grab Bar
Brushed Nickel Finish
YG0424BN – 24" Grab Bar
Brushed Nickel Finish
YG0436BN – 36" Grab Bar
Brushed Nickel Finish
YG0442BN – 42" Grab Bar
Brushed Nickel Finish
1. Please note that screws MUST be mounted into a wood stud for secure installation.
2. Decide whether you would like to position your grab bar horizontally, vertically or at an angle,
remembering that BOTH ends of the grab bar MUST be positioned over a wood stud (unless using
secure mount anchors).
3. Foreasierinstallationandmountingremove3setscrewsfromeachangeandremovebarfrom
SecureMount™ Flange.
4. Removecoverandre-assembleangetobarbytightening3setscrews.
5. Placegrabbarandmarkthreemountinglocationsoneachofthetwograbbarangeswitha
pencil.
6. Drill 1/8" diameter pilot holes at each screw location. Make sure to drill into the stud.
7. Install3screwsandwasherseachSecureMount™angeandtightenuntilsecure.Ifdesired,apply
silicone caulk to the back of the SecureMount™ plate to guard against water penetration.
8. Afterscrewsareinstalledeachside,dis-assemblebarfromSecureMount™angebyremovingset
screws.
9. Re-install covers.
10. PlacebaroverSecureMount™angesandtightenallsetscrews.
11. Snap on covers.
Topreservethenenishofthisproduct,cleanonlywithasoftdampcloth.Dry
well. Do not use commercial or abrasive cleaners.
Grab Bar posts and bars are constructed
of stainless steel.
• ADA, ANSI, ASTM, CSA
• Tested to 500lbs. pull
Stock Number: _______________________ Grab Bar
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321-8809 • FAX: (800) 848-6636
INTERNATIONAL: (440 ) 962-2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
WWW.MOEN.COM
©
2015 Moen Incorporated. Moen is a registered trademark and Align is a trademark of
Moen Incorporated. All rights reserved.
3.25"
(82.5 mm)
A
B
1.25"
(31.8 mm)
2.95"
(74.9 mm)
1.5"
(38.1 mm)
Dim. A Dim. B
YG0412 12 15.25
YG0418 18 21.25
YG0424 24 27.25
YG0436 36 39.25
YG0442 42 45.25

Summary of content (1 pages)