Use And Care Manual
Mountain Morning GT06 tile shown
TILE CARE & MAINTENANCE PAGE 6 OF 7
TILE CARE &
MAINTENANCE
MOSAIC (GLASS AND MIXED MATERIALS)
General Cleaning
Tile, whether glazed ceramic or porcelain, should be
maintained on a regular and frequent basis to prevent
build-up of soil, grease, residue, soap detergents,
sealers, dampness, liquids, etc., to keep the surface
clean and lessen slippery conditions.
Glazed ceramic and porcelain tiles require minimal
maintenance. Either can be cleaned with clear water and/
or a pH neutral liquid cleaner (soapless). Follow with a
clear water rinse and wipe dry to prevent lm formation.
As with most porcelains, spilled liquids may stain
light-colored products if not promptly removed. Neither
sealing nor acid cleaning is recommended for any of
Daltile’s glazed ceramic or porcelain tile.
Glass Tile
Use a glass cleaner and a soft lint-free cloth for
cleaning glass tile. To remove soap scum or water
deposits a minimally abrasive cleanser and soft
bristle brush can be used.
STONE MOSAIC
Routine Care
Natural Stone products are porous by nature and many
of the cleaners acceptable for use on ceramic tile can
stain, damage or dull stone.
Dirt and dust will scratch the surface of stone. Natural
Stone should be cleaned with neutral cleaners and
should never contain acid or bleach. Acids, even a light
solution of vinegar and water, will etch and eventually
damage Natural Stone.
Stone Cleaners
Only use cleaners specically designed for cleaning
stone. These cleaners contain no acids and are
concentrated neutral pH cleaners that will not aect
existing sealers or wax-type coatings. The surface of
the stone should be dampened with clear water. This
will keep the cleaning solution on the surface so it can
be eective. A solution of the cleaner and water mixed
to manufacturer’s instructions should be applied to the
stone surface with a sponge or mop.
On walls, kitchen counters or vanity tops, a spray bottle
can be used to apply the cleaning solution. Allow sitting
for manufacturer’s specied amount of time (usually
3 to 5 minutes). Agitate with a sponge, synthetic mop,
soft bristle brush or through the use of a oor scrubbing
machine. Mop up dirty solution and bu dry.
Once the stone has been cleaned, you can periodically
apply a spray-bu wax-type oor nish to enhance the
beauty and luster of polished stone. Apply the nish
with a spray applicator and bu immediately with a
white nylon pad.
Pre-Grout Sealing
A non-sanded grout is strongly recommended for
Natural Stone installations due to the narrow grout
joints customarily preferred. All travertine, slate, tumbled
stone and honed/amed/unpolished granite should be
sealed prior to the grouting process to protect them
from staining. The application of a good quality sealer
should be used as a grout sealer and applied again as
the nal sealing process once the installation is nished.
Metal Tile
To clean, use a liquid non-abrasive household cleaner.
DO NOT use scouring pads, steel wool, sandpaper or
other abrasive products. Avoid cleaners containing
ammonia, bleach, abrasives, or other hazardous/
polluting compounds. Always test in a small
inconspicuous area while using a new cleaner to
ensure compatibility.