Owner`s manual

CONTROL PANEL
Digital Display
Press the power button once to turn the
unit on*. Initially there is a slight
delay
while the electronics calibrate.
Two bars (
- -) appear during this time.
Once calibration is complete a R
OOM
humidity reading between 20%
- 95% will
be displayed. A flashing 20 display
indicates that the room humidity is less
than 20%.
NOTE:
The default settings at initial startup are (LOW) F1 fan speed and 65%
SET
humidity. After desired settings are selected by the user, they remain as long
as the unit remains plugged in and there is no power interruption. When the unit is
unplugged, the
original default settings are reinstated.
* Humidifier fan should operate at initial start up. If it does not, refer to “Fan not operating
(digital display is illuminated n Trouble Shooting Table.”
HUMIDITY SETTING
.
This button allows you to adjust the
humidity to suit your needs. This
humidifier will automatically cycle on
and off as required to maintain the
selected setting.
The readout displays both actual
(ROOM) and desired (SET) humidity percentage (%)
settings when humidity control button is pre
ssed. The ROOM readout has a range of
20% to 95% Relative Humidity (RH). If the room humidity level is equal to or less than
20% RH the display will show a flashing 20. The
SET readout has a range of 25% to
65% RH and is adjusted in increments of 5%. Initi
ally depressing the humidity button
will display the current humidity setting. Each additional press of the button increases
the setting by 5%. A
SET point of 65% RH operates the humidifier continuously
regardless of the
ROOM reading. The humidistat that senses the readings is located
on the power cord. Insure that it is free from obstruction.
FAN SPEED
This humidifier is equipped with a 3
-speed
fan control. Initially depressing the speed
button will display the current speed
setting.
Each push of the speed button
advances the
mode through the settings of
(HIGH) F3, (MEDIUM) F2 and (LOW) F1.
The selected setting is displayed on the
digital readout. The higher the setting,
the faster water is evaporated and released into the air.
F1 (LOW) is the quietest
setting and is provided for conditions that do not r
equire a rapid evaporation rate.
NOTE: When excessive condensation exists, a lower speed setting is recommended.
6