User guide

OVERVIEW ..................................................................................... 1

INSTALLATION and POWER .......................................................... 1

Installation ............................................................................... 2

Power ...................................................................................... 2

USB Programming Cable and Software ................................ 3

SENSOR CONNECTIONS ............................................................. 3

OUTPUT OPTIONS ......................................................................... 4

Current Output Option (IO) ...................................................... 5

Analog Output Option (AO) ...................................................... 6

Pulse Repeater Option (PO) ................................................... 6

SPECIFICATIONS ........................................................................... 7

OPTIONS ........................................................................................ 8

ACCESSORIES / SENSORS .......................................................... 9

APPENDIX A - Serial Programming Commands ......................... 10

TABLE OF CONTENTS

@CH_A/LOEND = 12 (or 1_SEC, HALF) Sets low end time. This allows a

min reading of 5 RPM, 60 RPM, or 120

RPM.

@CH_A/GATE Shows Gate Speed. (Default is 12)

@CH_A/GATE = STD (1/100 Second) or FAST (1/1000 second). Sets

Gate Speed (Default is 1/100)

@DECPT Shows the number of decimal places

displayed

@DECPT = NONE, 1, 2, or 3 Sets the maximum number of decimal

places

@DAC1/ FSCAL Shows Analog Out Full Scale

@DAC1/FSCAL = xxx.xx Sets the Reading value that the Analog

output will output Full Scale (5V or

20mA). Depends on TYPE.

@DAC1/0SCAL Shows Analog Out Zero Scale

@DAC1/0SCAL = xxx.xx Sets the Reading value that the Analog

output will output Zero Scale (0V or

4mA). Depends on TYPE. (Default is

0.00)

@OUTPT Shows pulse output polarity

@OUTPT = POS or NEG Sets pulse output polarity

@DISPR Shows Display Update Rate

@DISPR = HALF or 1_SEC or 1.5_S. This sets the maximum display

update rate to one half a second, 1 second

or 1 ½ seconds between updates.

@SERNO Shows unit Serial Number