User guide

2
Installation
Remove the mounting clips, if fitted, and install the unit into the panel from
the front. From the rear of the unit, install the mounting clips on each side
and tighten the mounting screws against the rear of the panel.
WARNING: Do not over tighten the mounting screws.
Power
Power to the unit is connected to the terminals under the section labeled
POWER on the rear panel. Be sure the power supplied matches the
specification indicated on the rear panel. Refer to Figure 2 below.
Figure 2 ACT-1B Rear Panel
If the unit is ac powered (100 - 240 Vac), connect the Live (Hot) wire to
the terminal marked L+ and the Neutral (Return) wire to the terminal
marked N-.
If the unit is dc powered, connect the dc supply Positive to the terminal
marked L+ and the dc supply Negative or Common to the terminal
marked N-.
USB
Programming
Jack
9
ACCESSORIES / SENSORS
T-5 Reflective Tape - 5 foot (1.5 m) roll, 0.5 inch (10 mm) wide
USB Programming Cable with PM Remote Software on CD:
Enables the user to program the ACT-1B using a PC with
USB connection. The software also allows remote monitoring
of the RPM using a graphic display or an Excel
TM
spreadsheet.
ROLS-W Remote Optical Laser Sensor with 8 foot cable
ROS-W Remote Optical Sensor with 8 foot cable
ROS-P-25 Remote Optical Sensor with 25 foot cable (must cut plug off)
ROS-HT-W-25 Remote Optical Sensor for high temperature applications
to 257 °F (125 °C) with 25 foot cable
P5-11 Proximity Sensor
M-190W Magnetic Sensor with 8 foot cable
MT-190W Magnetic Trigger Sensor with Amplifier Module, 8 foot cable
GE-200 Gasoline Engine Electromagnetic Inductive Sensor and
amplifier with 23 feet of cable
IRS-W Infrared Sensor with 8 foot cable