User guide

2.0 INSTALLATION AND SETUP

2.1 UNPACKING

2.1.1 Initial Inspection

Exercise care when unpacking the instrument from the shipping carton. The instrument

is packed in a custom cardboard box to prevent damage during normal transit. If

damage to the shipping carton is evident, ask the carrier’s representative to be present

when the instrument is unpacked.

2.1.2 Unpacking Procedure

To unpack your Recorder, first remove the cardboard retainer and instrument from the

shipping carton. Check the box for the following contents - The Recorder, two locking

bars, two 6-32 x ½" screws, AC power supply wall unit (unless the unit is the isolated

DC model) and this manual.

2.1.3 Detected Damage

Remove the instrument from the plastic bag and check for damage if any. Also check

that the unit is as ordered. If damage is detected after unpacking the instrument,

immediately report any damage to the shipping agent and re-pack the instrument for

return it to the factory as described in the following section.

2.1.4 Equipment Return

Before returning a damaged or malfunctioning instrument to the factory for repair,

contact the sales organization from which you purchased the instrument. A Return

Merchandise Authorization (RMA) number must be obtained from the factory before

returning an instrument for any reason.

2.1.5 Storage

For prolonged storage before installation, re-pack the Recorder in the shipping

container and store in a cool, dry area. We do not recommend storage of the Recorder

for more than one year. If longer storage time is required, contact the factory for

additional storage information.

2.2 INSTALLATION

The instrument is intended to operate in the following environment:

Indoor Use Only

Installation Category II per IEC 664

Pollution Degree Level II per IEC61010-1

Temperature -10 °C to 50 °C operating per IEC61010-1

Humidity Maximum relative humidity 80% for temperatures up to

31 °C decreasing linearly to 50% relative humidity at 40 °C

Recorder Power 9.0 +0.5V dc @ 5VA (unless indicated otherwise on the unit)

AC Power Requirement (External adapter) 100 - 240 Vac ~ 50/60 Hz

NOTE: The recorder is designed to be panel mounted and as such should be considered

as permanently connected. Disconnection from the supply must be possible via a customer

supplied switch or circuit breaker. This disconnection device must be included in the panel

installation and should be clearly marked, it must be in close proximity to the Recorder and

easily accessible to the operator.

TABLE OF CONTENTS