User guide

20
3.5 MENU MODE
At any time when in normal view mode, pressing the MENU button will
bring up the user menu as shown to the right. Note that the menu
"pops up" over the graphics display. The unit continues to record and
will not lose data. There is also a time out option that will return a
menu display back to a graphic display after a period of inactivity.
(Refer to Advanced Setup DISPLAY - MENU TIMEOUT).
 When the menu is active, the Left Arrow (◄) and Right Arrow
(►) buttons act as ESCAPE keys to return to a previous level
without activating any function.
The user moves about the menu using the Up Arrow (▲) and Down
Arrow (▼) buttons. The current selection is always highlighted in
reverse. To select a function, simply move to it with the (▲) and (▼)
buttons and then press the MENU button once. To go back a level without activating any
function, simply press the (◄) or (►) buttons. Note that the menu has more options than
can be displayed at once on the screen. When a selection gets to the top or bottom of the
menu list, the list will scroll until the last entry is reached then wrap around. Pressing and
holding the (▲) and (▼) buttons will activate an Auto Repeat function and cause the
highlight bar to scroll automatically.
The menu has multiple levels. An option with a secondary level is indicated by .. after the
name. Access to the various levels can be controlled by a password (Refer below).
3.5.1 EXIT!
When the menu is displayed, it defaults to the EXIT selection. At this point, pressing the
MENU button will return to the graphic display.
3.5.2 ALARM RESET!
Pressing the MENU button after selecting ALARM RESET! will reset any alarm that is
active and latched and then exit the Menu Mode. When the alarm is not latched, but is
still in alarm, selecting this option will briefly reset the alarm, which will then activate
again.
3.5.3 RESET TOTAL
To reset any channel programmed as Totalizer (Refer to XXXX), press the MENU
button, use the Up Arrow (▲) or Down Arrow (▼) button to highlight RESET TOTAL
and then press the MENU button again. A sub menu will appear with choices to select
CHAN A, CHAN B and BOTH. Use the Up Arrow (▲) or Down Arrow (▼) button to
highlight the Channel to reset, or choose BOTH to reset both channels synchronously
and press the MENU button. Press the Left (◄) Arrow button to exit.
3.5.4 RECORD MODE
To begin or end recording in the data card, press the MENU button, use the Up Arrow
(▲) or Down Arrow (▼) button to highlight RECORD MODE and then press the MENU
button again. Several options appear in a sub window: OFF, ON and TRIGGERED. To
exit at this stage without changing the current setting, press either the Left (◄) or Right
(►) Arrow button. Otherwise, use the Up Arrow (▲) or Down Arrow (▼) button to make
a selection and then press the MENU button. The active selection is indicated by a  to
the left of the option. If you are using the alarms or external input to control the recording,
select TRIGGERED for triggered operation. OFF and ON will always stop or start a
recording irrespective of the state of any of the record triggers. (Refer to Event Triggering.)
EXIT! ….. .
ALARM RESET
RESET TOTAL..
RECORD MODE..
CURSOR ID
VIEW FILE..
CARD STATUS
INFO
SAMPLE RATE..
PASSWORD..
ADV.SETUP..
DISPLAY ADJ..
UNIT TAG
TABLE OF CONTENTS