User guide

22
To return to the current real time trend, press the MENU button. View File will
automatically abort if the data card is removed.
3.5.7 CARD STATUS
To display the status of the memory card, press the MENU button, use the Up Arrow
(▲) or Down Arrow (▼) button to highlight CARD STATUS! and then press the MENU
button again. A pop-up window will be displayed showing information about the memory
card including the size of the card, the amount of space left as a percentage and the
equivalent record time at the current settings.
To remove the Card Status pop-up window, select CARD STATUS! again.
3.5.8 INFO
To display the System Information press the MENU button, use the Up Arrow (▲) or
Down Arrow (▼) button to highlight INFO! and then press the MENU button again. This
will show the Firmware revision and build as well as the MAC Address of the Ethernet
option if fitted on the TREND screen. If the TREND screen is not displayed, this menu
option will have no effect. Press the Up Arrow (▲) to remove the information from the
TREND screen or leave it to scroll off the trend screen at the chart speed rate.
3.5.9 SAMPLE RATE
To adjust the sample rate (the rate at which data is recorded and displayed), press the
MENU button, use the Up Arrow (▲) or Down Arrow (▼) button to highlight SAMPLE
RATE and then press the MENU button again.
 The SAMPLE RATE menu option may be password protected.
When entering the SAMPLE RATE menu, the rate highlighted is the current sampling
rate. To exit at this stage without changing the current setting, press either the Left (◄)
or Right (►) button. In this manner the user can check the current sampling rate at any
time without affecting the recording.
To change the sampling rate, use the Up Arrow (▲) or Down Arrow (▼) button to
highlight the desired sample rate and then press the MENU button. The sample rates
vary from a high of 100 S/sec (Samples per second) to the slowest 10 min/S (minutes
per sample, sec/S is seconds per sample).
To return to the graphic screen, press either the Left (◄) or Right (►) button.
3.5.10 PASSWORD (PROTECTION)
To set, reset or change a password, press the MENU button, use the Up Arrow (▲) or
Down Arrow (▼) button to highlight PASSWORD and then press the MENU button.
 This menu option may be password protected.
Follow the prompts. Enter a 4-digit password using a combination of ◄►▼▲ buttons.
The key presses are echoed in a pop-up window and roll around, first in first out. Once
you have entered your password, press the MENU button.
If you are entering a new password, you will be asked to repeat your password and
then press the MENU button. At this point the password is entered and the unit is
protected.
To clear the password, enter the current password and then simply press the MENU
TABLE OF CONTENTS