User guide

27
LOW SCALE
Default value is low end of range. For Offset. Use ▼▲►
keys to adjust. ◄ key escapes, MENU key to Save and Exit
HIGH SCALE
Default Value is top end of range. For Full Scale. Use
▼▲► keys to adjust. ◄ key escapes, MENU key to Save
and Exit
CHAN TAG
Enter a Channel Tag Identifier up to 5 Characters. Use
▼▲◄► keys. Use MENU key to Save and Exit
CHAN UNITS
Default value is Range value. Enter a Channel Units. Some
Ranges have defaults up to 3 Characters. Use ▼▲◄►
keys.
Use MENU key to Save and Exit
FILTER
Note: Unit always samples at 100 samples/sec internally
NORMAL
No filtering
AVERAGE
Display shows AVERAGE over last sample interval
HI PEAK
Display shows HI PEAK (max) values over last sample interval
LO PEAK
Display shows LO PEAK (min) values over last sample interval
TOTALIZER
RESET
TOTAL
Reset Totalizers on Chan A, Chan B or Both
AUTO
RESET
Select whether to reset total on Alarms or External Input
GATE
Select whether to reset total on Alarms or External Input
/SEC. x1k ../DAY
x 100
Select Totalizer Rate from per second displayed x 1000
to per Day x 100. (4 Digit Display)
FAST FILT
averages last 10 samples continuously
CALIBRATION
CAL ZERO
(If applicable) - Input zero and adjust ▼▲for zero. MENU to
accept.
CAL SPAN
Input Max Span value and adjust ▼▲for correct value.
MENU accepts.
CAL NOMIN.
Copies default calibration value
CAL ALL
4.2 ALARMS
This option is used to program the alarms. There are four alarms and each is programmed
independently. Each alarm may be turned on or off and may be assigned to either channel.
Use the Up Arrow (▲) or Down Arrow (▼) buttons to scroll and highlight ALARMS.. and
press the MENU button. The menu options are shown expanded below.
ALARM n (N=1,2,3,4)
ENABLE
Turn Alarm 1 on or off -  ENABLED is on
HIGH
Select if ALARM is HIGH
SETPOINT
Set ALARM Trip point. Use ▼▲► keys to adjust
◄ to escape, MENU key to Save and Exit
DEADBAND
Set ALARM DeadBand point. Use ▼▲► keys to adjust
◄ to escape, MENU key to Save and Exit
CHAN A
Select CHAN A as Source for Alarm
CHAN B
Select CHAN B as Source for Alarm
LOW
Same as HIGH
Select if ALARM is LOW
TABLE OF CONTENTS