Owner's Manual

AV Positioning
Please refer to the illustrations below for the ideal angles and positions of each speaker in your surround
system. The speakers should be distanced from the wall according to the requirements of the speaker,
which are listed in the 2-Channel Positioning section (page 2). However due to AV receiver crossover lter
settings, they may be positioned closer to the wall. Experimentation is advised.
If the sound is too bass heavy or there is bass boom from the room when playing music (without a
subwoofer), try moving the loudspeakers slightly further away from the wall(s). If this is not possible, then try
the supplied port bungs. In a system with a subwoofer try adjusting the crossover frequency settings for the
speakers and/or sub or changing the subwoofer’s position.
-30° 30°
-22° 22°
150°-150°
135°-135°
110°-110°
90°-90°
-30° 30°
-22° 22°
150°-150°
135°-135°
110°-110°
90°-90°
A A
B
B
The Silver C250 centre channel speaker should be
positioned so that it is pointing at the viewing position and
at approximate ear height.
NOTE: The images below are for illustrative purposes only. If
using the Silver FX please refer to the next section for further
information.
A. Side surround speakers
B. Rear surround speakers
A 7.1 surround system will make use of side (position A) and
rear speakers (position B) to create a full 360° soundstage,
if setting up a 5.1 system you can place your surrounds in
position (A).
Setting up the Silver FX
The Silver FX features Di-Pole or Bi-Pole listening modes. In Bi-Pole mode, the driver and tweeters are all in
phase. In Di-Pole mode one of the tweeters is out of phase to the other tweeter and main driver to create
the diffused sound. The FX speakers should be wall mounted approximately 2 feet above ear height.
Di-Pole/ Bi-Pole switch: When part of 5.1 systems set the switch to Bi-Pole. Although there is nothing wrong
with experimenting and trying the switch in the Di-Pole mode.
If part of a 7.1 system with 1 pair of FX’s set the switch to Bi-
Pole. If using 2 pairs of FX’s for side and rear effects, set them
all to Di-Pole mode and swap the left and right handed
side FX speakers over, keeping the rear FX speakers handed
correctly (matching left and right with the front left and right
channels) as illustrated.
NOTE: Before adjusting any switches, please ensure
that the amplier is at the very least turned off. This will
help to protect the amplier.
monitoraudio.com 3
English
Right Left
RightLeft