Owner's Manual

Bronze Series2
Attaching Feet and Spikes
For Carpeted Floors
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
SHEET 1 OF
1
DRAWN
CHECKED
QA
MFG
APPROVED
chris
26/11/2019
DWG NO
TITLE
SIZE
D
SCALE
REV
1 : 1
A
(Bronze 200 and 500 only)
The spikes and ‘out-riggers’ are supplied assembled for
use on carpeted floors or where spikes are appropriate. All
that is required is to fix them to the speaker base using the
supplied bolts (A & B).
You can check that the speaker is level on all sides by using
a spirit level (not supplied). If it’s slightly off-level, unscrew
the spike and check again. Continue this process until the
cabinet is fully level. Use the locking nuts on each foot to fix
the spike in place and to stop any unwanted vibrations.
Please ensure there are no hidden wires under the carpet that could be damaged by the
spikes.
For Wooden/ Hard Floors
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
SHEET 1 OF
1
DRAWN
CHECKED
QA
MFG
APPROVED
chris
26/11/2019
DWG NO
TITLE
SIZE
D
SCALE
REV
1 : 1
A
B
(Bronze 200 and 500 only)
Remove the spikes and replace with the supplied rubber feet.
Fix the ‘out-riggers’ to the speaker base with the padded
side touching the cabinet using the supplied bolts (A & B).
You can check that the speaker is level on all sides by using
a spirit level (not supplied). If it’s slightly off-level, unscrew
the rubber foot and check again. Continue this process until
the cabinet is fully level. Use the locking nuts on each foot
to fix them in place and to stop any unwanted vibrations.
Setting Up Your Loudspeakers
2 Channel Positioning
xm
xm
xm
When arranging a 2 channel (stereo) system, the listening
position and the loudspeakers should form an equilateral
triangle. The speakers should be positioned approximately 6 -
10 feet (1.8 - 3 m) apart. The ideal distance from the rear wall
varies depending on the speaker (see list below), however, for
optimal performance they need to be a minimum of 3 feet (91
cm) from the side walls.
Bronze 50 6 - 12 inches (15 - 30 cm)
Bronze 100 & 200 8 - 14 inches (20 - 36 cm)
Bronze 500 12 - 24 inches (30 - 61 cm)
NOTE: These are recommended distances for optimal
performance. Actual results will vary dependant on room
size and construction.
Experimentation is strongly advised when initially setting up the speakers, as environment and personal
preference differ with every installation. If there is insufficient bass for example, try moving your speakers
closer to a wall. The opposite approach is recommended if there is excess bass. Also see the information
in the Port Bungs section. If stereo imaging is being lost, try ‘toeing’ them in slightly. The sound should
appear to originate from the centre point between the speakers, not the actual speakers themselves.
B
A = M10 x 1.25 x 16 mm
B = M4 x 1.25 x 16 mm
A = M10 x 1.25 x 16 mm
B = M4 x 1.25 x 16 mm