Owner's Manual

Running-In Your Speakers
Run your speakers in by playing music at low-mid listening levels for approximately 50-70 hours play time.
You may find the sound will continue to improve even after the 70 hour mark.
This can be done naturally over time: like a fine wine the performance will improve with age.
Alternatively if you wish to run the speakers continuously on loop you can decrease the audible volume/
presence by placing the speakers face-to-face so that the drivers/tweeters are directly aligned and as
close as possible. Then connect the amplifier to your speakers so that one is as normal (in phase): positive
to positive and negative to negative (red to red and black to black), and the other speaker out of phase:
positive to negative and negative to positive inputs on the speaker.
Retention Bolt Adjustment
The Bronze Series has a bolt-through driver fixing to reduce cabinet colouration. Each bolt acts as a rigid
brace, but also removes the need for conventional driver fixings as well, effectively decoupling the driver
and front baffle to eliminate a further source of resonance.
NOTE: Should this bolt become loose over time, or has worked loose during transit, then please use
the supplied hex key to tighten the bolt back up. This only needs to be a quarter turn after the strain
has been taken by the bolt.
Warranty
Both the craftsmanship and the performance of this product is covered by the manufacturer’s warranty
against manufacturing defects provided that the product was supplied by an authorised Monitor Audio
retailer under the consumer sale agreement. For the period of cover please refer to the product page on
our website: monitoraudio.com for the product you have purchased.
When purchasing Monitor Audio products, please keep your receipt of purchase safe, as this validates your
warranty.
Owner Information
Product Details
Model:
Product Serial No:
Date of Purchase:
Dealer Details
Dealer Name:
Address:
Post code:
E-mail address:
monitoraudio.com 7