Owner`s manual

STEP 8 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
• To level the back of the refrigerator, turn the 7/16”
hex nut located above
the front wheels. Turn
clockwise to raise or
counterclockwise to lower
the refrigerator.
• For front leveling, use a
1-1/4” open-end wrench.
• Adjust height of
refrigerator to match
installation cutout opening
84-1/2”. The refrigerator should be level and plumb
with cabinetry .
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1”.
If the installation requires more than 84-1/2” height,
the installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinetry trim could also be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator more
than 1”, you will damage the front leveling legs and
the rear leveling wheels. Make adjustments in small
increments.
34
Installation Instructions - Flush Installation
We recommend units for flush installation be installed
under a soffit. If this is not possible, follow these
instructions using the mounting brackets.
• Cut a 2” x 4” block, 35” long and secure the block to
the mounting brackets provided using #12 or #14
wood screws.
• Secure the bracket
with wood block
to the back wall so
that it is 84” from
the finished floor.
Use #12 or #14
wood screws. See
the illustration.
• The screws must
penetrate at least
one inch into the
vertical wall studs.
• If metal wall studs then use self-tapping sheet metal
screws in place of the wood screws to secure the
block and brackets to the wall.
STEP 7 ANIT-TIP PROCEDURE (continued)