Owner`s manual

Installation Instructions
ISTEP 11 REMOVE PACKAGING
• ]_einove corner blocks and flmm drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
CAUTION: s,,,.u (,bje(-ts area choke hazard
fl)r children. Remove and discard any parts not used.
ATTENTION : petits.bietspe.,e.t
_trangler les enfimts. 11 fautjeter toutes les pi_ces qui
ne sont pas utilis_es.
ISTEP 21 LEVEL
• Use an a(!justable wrench to tm'n and raise or lower
the leveling legs.
• Measure floor to co/mtertop height inside tile
opening. Ac!j ust leveling legs until the l)ro(htct is
approximately 1/8" less than co/mtertop height.
TurnRightto Lower
TurnLeftto Raise
INSTALLATION TIP:
Measm'e floor to underside of countertop inside tile
opening.
• If tile room floor is higher than tile floor inside tile
opening, a(!just the rear leveling legs to approximately
1/8" less than the opening height, Screw fl'ont leveling
legs all the way in to shorten the height at the fl'ont,
This will allow you to slightly tip the refit into the
opening. Once tile trait is in tile correct position, tile
fl'ont legs can be a(!justed to level tile product.
ISTEP 31 CONNECT POWER
• If the refl'igerator is used outdoing, plug tile power
cord into a GFCI receptacle.
• Check to make sm'e power is on by opening tile door
to see if interior light turns on.
• The interior tim rims at all times except when the
door is open. See the the Owner's Manual tor fl,rther
explanation.
ISTEP 41 SLIDE PRODUCT INTO
THE CUTOUT
CAUTION: D,,t,,tti.ltsh.g.it,sttiledoor
with yore" knees. Do not push or lift tile trait bv tile
door handle. Damage may occur!
ATTENTION : Ne i)oussezjamais la porte
avec vos genoux. Ne poussezjamais votre appareil ou ne
le soulevezjamais par la poign_e de porte. Vous pouvez
1'endotlltllager.
• Open the door and gently push the unit back into the
opening with wmr hands against the sides. Be carefltl
not to entangle power cord.
• In a standard 24" opening, tile door will protrude
l-I/2" fi)rward of tile surrounding cabinets.
• Check again to be sure the trait is level.
• If tile trait is installed trader a countertop, a@tst tile
leveling legs until the trait is resting firmly against
tile bottom of tile co/mtertop.
• If aligmnent with a(!jacent cabinetry is an issue,
use a shim to secure the unit against the tmderside
of tile co/mtertop.
• Test the door swing. Carefidly open and close the
door. Tile door should not mb or catch on a(!iacent
cabinett T, Noti{}' the installer if the door makes
contact with cabinetry,
ISTEP 51 SET TEMPERATURE
CONTROLS
• Tile temperature controls are preset. Reter to tile
Owner's Manual fi)r more inflmnation. Allow 12-24
hours fl)r temperature to stabilize.
NOTE: The Outdoor/Indoor Refl'igerator operates
very quietly. You may not notice the unit t mining, and
when first installed, the rims and motor may not come
on immediately--this is normal. If the displayis lit
and the light is working, the unit is operating.
6