Specifications

Design Guide
FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES
THE INSTALLATION SPACE
IMPORTANT: Double-Drawer Refrigerators ore
designed to be built-in onlg. Theg cannot be used
free-standing.
23-3/4"Min
NOTE: Handles
not supplied.*
24-7/8''_
] 3:1j4
to 34-3/4"
__ 23-3/4......
*Custom handle clearances may vary, depending on the
standoff of the custom handles.
The cutout depth should be 24"
The cutout dimensions shown allow for full drawer
extension.
NOTE:The drawers should be flush with the surrounding
cabinets.
Additional Specifications
A 120 volt 60Hz., !5 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded
3-prong electrical receptacle recessed into the back
wall as shown. Electricalmust be located on rear wall
as shown. NOTE:GFCI(ground fault circuit interrupter)
is not recommended.
PRODUCT CLEARANCES
When installed /
in a corner:
11,,
CounteRop
Double-Drawer
Z-,,"23-1/8"min.
/
ClearanceforDoor
Opening2-1/2"min.
Allow 2-1/2" min.clearance between Double-Drawer and
adjacent cabinet, wall or other appliances.Allow 23-:]z8"
min. clearance from the front for drawer opening.
NOTE:Custom handle clearances may vary depending on
the standoff of the custom handles.
Test the drawer openings. Carefully open and close
the drawers. The drawers should not rub or catch on
adjacent cabinetry. Notify the installer if the drawers
make contact with cabinetry. NOTE:When installing
custom panels and handles,use above clearances as
a general guide but adjust according to the installation.
Choose the locution:
These products may be closed in on the top and
three sidesas long as the front is unobstructed for
air circulation and proper accessto the drawers.
Do not install these products where the temperature will
go below 55°F(13°C)or above 90°F(32°C).
These products are not designed to be stacked one over
the other.
Black or Stainless Steel Toekick Options
These products are shipped with two toekicks,
a stainlesssteel and a black toekick. For shipping
purposes, one of the toekicks will be secured to
the back of the unit and the second will be installed,
in place, on the unit. Keepthe unused toekick,
and other unused or removed parts, for future use.
SIDE-BY-SIDE INSTALLATIONS-
Custom Panel Models Only
For a complete refreshment center, install a Double-Drawer
Refrigerator beside a Beverage Center or Wine Chiller/
Wine Reserve.
A side-by-side installation requires at least a 47-1/2" wide
opening. No trim kits required.
Products must operate from separate, properly grounded
receptacles.
T I I 1 14"10-1 /2"
34-1
r___,Mi __ __ ,,
*NOTE:Additionalclearunces
may berequired.