Installation Instructions

31-1000600 Rev. 1

Installation Instructions - Custom Overlay Door Panel

STEP 3 ADJUST OVERLAY PANEL (Cont.)

After the panel has been adjusted to the desired

position, secure the panel by first driving and tightening

the vertical screws at the bottom of the door brackets

and then drive and tighten the remaining horizontal

screws. ALL 12 SET SCREWS should be driven and

firmly tightened in order to properly secure the panel.

Ŷ After the top and bottom door panel brackets are

secured by installing / tightening all 12 set screws, use

1/4” Phillips screw and square washer to secure the

center mounting bracket.

Square

Washer

Center

Mounting

Bracket

1/4” Phillips screw

STEP 4 IF DOORS WERE REVERSED COMPLETE THE

FOLLOWING STEPS

Ŷ Top cover assembly shipped in box on side of product.

Remove screws and nuts to remove rectangular cover.

Retain parts to build new top assembly.

Ŷ Mount rectangular cover to bottom cover (removed

during door reversal) utilizing the screws and nuts that

were removed from top assembly. Be sure to align the

edges during assembly.

Rotate

180 degrees