Owner's Manual

ManualsBrandsMonogram ManualsFreezersMonogram 36 Inch Wide 21.9 Cu. Ft. All Freezer with Concealed Ice Drawer and Left Hinge Door Swing

Installation Instructions - Flush Installation

Remove Grilles for Access to Anti-Tip Locking Hooks

Fresh Food Unit

• Open the access door.

• Remove the 4 screws from the grille on the right and 3

screws from the grille on the left.

• Pull the bottom of the grille forward, down and out to

remove.

Freezer Unit

• Open the access door.

• Remove the 4 screws from the grille on the right and 3

screws from the grille on the left.

• Pull the bottom of the grille forward, down and out to

remove.

Power Cord

Locate the power cord inside the left cavity. If it has not

been adjusted so the plug is easily accessible, do so

now.

Move Unit into Final Position

• Move appliance toward its final installed location. Align

the tabs on the wall bracket with the openings in the

back of the unit.

• The unit has “L” bolts in the upper left and right

corners inside of the access compartment. These bolts

will interlock with the wall bracket and secure the unit

using the washers and hair pin cotters in the hardware

kit once the unit has been leveled and is in the final

position.

STEP 5 INSTALL ANTI-TIP BRACKET (cont.)

STEP 6 LEVEL UNIT

All models have 4-point leveling. The front is supported

by leveling legs; the rear is supported by adjustable

wheels. Both are accessible from the front of the unit.

• To level the back of the unit, turn the 7/16” hex nut

located above the front wheels. Turn clockwise to raise

or counterclockwise to lower the unit.

• For front leveling, use a 1-1/4” open-end wrench.

• Adjust height of unit to match installation cutout

opening 84-1/2” (214.63 cm). The unit should be level

and plumb with cabinetry.

NOTE: Raise appliance until the case top comes in

contact with the 1” (2.54 cm) spacer block mounted to

the underside of the cabinet soffit. Appliance should be

level at fully raised position.

The rear leveling wheels and front leveling legs are

limited to a maximum height adjustment of 1”.(2.54 cm).

If the installation requires more than 84-1/2” (214.63 cm)

height, the installer should elevate the unit on a sheet of

plywood or runners. Cabinetry trim could also be added

across the top of the opening to shorten the opening. If

you attempt to raise the unit more than 1” (2.54 cm), you

will damage the front leveling legs and the rear leveling

wheels.

Screws Screws