Owner's Manual

Installation Instructions - Stainless Steel Installation

Move Unit into Final Position

• Move appliance toward its final installed location.

Align the tabs on the wall bracket with the openings

in the back of the unit.

• The unit has “L” bolts in the upper left and right cor-

ners inside of the access compartment. These bolts

will interlock with the wall bracket and secure the

unit using the washers and hair pin cotters in the

hardware kit once the unit has been leveled and is

in the final position.

STEP 4 INSTALL ANTI-TIP

BRACKET (cont.)

STEP 5 LEVEL UNIT

All models have 4-point leveling. The front is support-

ed by leveling legs; the rear is supported by adjustable

wheels. Both are accessible from the front of the unit.

• To level the back of the unit, turn the 7/16” hex nut

located above the front wheels. Turn clockwise to

raise or counterclockwise to lower the unit.

• For front leveling, use a 1-1/4” open-end wrench.

• Adjust height of unit to match installation cutout

opening 84-1/2” (214.63 cm). The unit should be

level and plumb with cabinetry.

The rear leveling wheels and front leveling legs are

limited to a maximum height adjustment of 1”

(2.54 cm). If the installation requires more than 84-1/2”

(214.63 cm) height, the installer should elevate the unit

on a sheet of plywood or runners. Cabinetry trim could

also be added across the top of the opening to shorten

the opening. If you attempt to raise the unit more than

1” (2.54 cm), you will damage the front leveling legs

and the rear leveling wheels.