Installation

Design Guide - Flush Installation
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted to 90°
if clearance to adjacent cabinets or walls is restricted.
When Installed into a corner:
Allow 15” for a full 115° door swing and pan removal.
Allow 4” min. clearance when door swing is adjusted
to a 90° opening for pan access, but pan removal is
restricted.
CLEARANCES
ZUG2 Unified Grille Panel Kit
• If you are installing two units, side by side, the installation space
must be 75” wide.
Note: Additional cutout width may be required when side panels
are used. Add side panel thickness to the finished cutout to
calculate rough-in width.
• The water and electrical locations for each product must be
located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply is
recommended for each product.
Note: When implementing a dual installation, the factory installed
standard case trim should be used on the handle side of each unit
and the supplied flush case trim should be used on the hinge side
of each unit.
75" Finished Width
4-5/16"
24-3/16"
9"
7"
7-1/2" 7-1/2" 7"
5-1/2"
9"
5-1/2"
Electrical
Electrical
Area
Cold Water
Supply
Wall View
Cold Water
Supply
26-3/16" Minimum
Cutout Depth
85"
Finished
Opening
3-1/2"
3-1/2" 3-1/2" 3-1/2" 3-1/2"
3-1/2" 3-1/2" 3-1/2"
3-1/2"3-1/2"
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door
swing product, a 1” clearance between the units is
required. Order ZUG2 Unified Grille Panel Kit for one con-
tinuous grille panel.
15"
Min. to
Wall
15"
Min. to
Wall
115° Door
Swing
1"
115° Door
Swing
38-3/4"
4" Min. to Wall
90° Door Swing
INSTALLATION
24
CUSTOM HANDLE DESIGN GUIDE
Custom handles must be used for flush installation. For
custom handle installation, counterbore holes in rear of
decorative panels must ensure 1/2” material thickness
remains for handle support.
NOTE: The counterbore must not exceed 1” in diameter.
Minimum distance from handle
side edge to handle center should
be 2-1/2” as shown.
1/4”
1/2”
3/4”
7/8"
0.85"
1/2"
2-1/2”