Installation

28
Design Guide - Flush Installation
3/4” RAISED GRILLE PANEL ROUTING
For 3/4” raised grille panel, routing is required. The router depth is 1/4” all the way around the panel back. Additional panel
width reductions are required per the diagrams below. This will create a “picture frame” routing that will slide onto the
attached grille trim.
3/4” PANEL SIDE VIEW
(AFTER ROUTING)
3/4” PANEL BOTTOM VIEW
(AFTER ROUTING)
Front
TOP
DETAIL TOP
CORNER VIEW SHOWING
“PICTURE FRAME” ROUTING
DETAIL BOTTOM
BOTTOM
LEFT
SIDE
RIGHT
SIDE
DETAIL
LEFT SIDE
DETAIL RIGHT
SIDE
Back
Front
Back
Front
Back
NOTE: Routed areas should be
finished as they may be visible
when assembled.
2-1/16” 2-1/16”
ROUTER DEPTH 1/4” ROUTER DEPTH 1/4”
1/8”
1-7/16”
ROUTER DEPTH 1/4”