Installation

• Gently pull back at the ends of the plastic straps to make
the channel rest flush behind the wall.
• Hold the ends of the straps in one hand and slide the plas-
tic cap along the straps until the flange of the cap is flush
with the wall.
• Place your thumb between the plastic straps and bend up
and down to snap the straps off at the wall.
Install Screws and Bolts:
• Have someone hold the wall bracket centered in place with
each of the holes aligned with the correct opening in the
bracket and level with the horizontal line.
• Insert the lag screws through the bracket and into the stud.
Tighten with a wrench.
•
Insert the bolts into the toggle by hand until snug. Tighten
with a wrench.
Anti-Tip Wall Bracket
Bolt
Wall Toggle
Drywall or
Steel Stud
Installation Instructions - Stainless Steel Installation
46
Wood Stud
Lag Screw
Anti-Tip Wall Bracket
Cap
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out
to remove.
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out
to remove.
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible,
do so now.
STEP 4 INSTALL ANTI-TIP BRACKET (cont.)