Installation

Installation Instructions - Stainless Steel Installation

Move Unit into Final Position

• Move appliance toward its final installed location.

Align the tabs on the wall bracket with the openings

in the back of the unit.

• The unit has “L” bolts in the upper left and right

corners inside of the access compartment. These

bolts will interlock with the wall bracket and secure

the unit using the washers and hair pin cotters

in the hardware kit once the unit has been leveled

and is in the final position.

STEP 4 INSTALL ANTI-TIP BRACKET

(cont.)

STEP 5 LEVEL UNIT

All models have 4-point leveling. The front is supported

by leveling legs; the rear is supported by adjustable

wheels. Both are accessible from the front of the unit.

• To level the back of the unit, turn the 7/16” hex nut

located above the front wheels. Turn clockwise

to raise or counterclockwise to lower the unit.

• For front leveling, use a 1-1/4” open-end wrench.

• Adjust height of unit to match installation cutout

opening 84-1/2”. The unit should be level and plumb

with cabinetry.

CAUTION

The rear leveling wheels and front leveling legs are

limited to a maximum height adjustment of 1”. If the

installation requires more than 84-1/2” height, the

installer should elevate the unit on a sheet of plywood

or runners. Cabinetry trim could also be added across

the top of the opening to shorten the opening. If you

attempt to raise the unit more than 1”, you will damage

the front leveling legs and the rear leveling wheels.

ATTENTION

Les roues de nivellement arrière et les pattes de

nivellement avant permettent un réglage maximal

de 25 mm (1 po). Si l’ouverture pour l’appareil

ménager a une hauteur supérieure à 2,15 m (84-1/2

po), l’installateur doit élever l’appareil ménager sur

une feuille de contre-plaqué ou des glissières. Il est

également possible d’ajouter des baguettes de finition

des placards sur le haut de l’ouverture afin de la

réduire. Lever l’appareil ménager de plus de 25 mm

(1 po) endommage les pattes de nivellement avant et

les roues de nivellement arrière.